Wiring guide
ecobee Smart Thermostat Premium wiring for 2-stage heat + 2-stage cool
Good news: the ecobee Smart Thermostat Premium is a direct swap for this setup. Every wire has a matching terminal.
W2 and Y2 mean a two-stage furnace and a two-stage AC. They run on low most of the time and step up on extreme days. Budget thermostats can’t run the second stages. Read the full 2-stage heat + 2-stage cool guide for how to confirm your setup and mistakes to avoid.
Wiring diagram
Detected system: 2-stage heat, 2-stage cooling, fan, C wire present · 7 wires
ecobee Smart Thermostat Premium
Works: direct swap| Wire | Color | Job | Connect to | Note |
|---|---|---|---|---|
| R | red | 24 V power | Rc | |
| C | blue | Common (C wire) | C | |
| W1 | white | Heat, stage 1 | W1 | |
| W2 | brown | Heat, stage 2 | W2 | |
| Y1 | yellow | Cooling, stage 1 | Y1 | |
| Y2 | orange | Cooling, stage 2 | Y2 | |
| G | green | Fan | G |
Install steps
- Turn off power to the furnace/air handler (switch or breaker) and the AC condenser. Confirm the old thermostat is dead.
- Photograph the old wiring, then label each wire with the letter it came off. Ignore short jumpers.
- Connect each wire to the ecobee Premium terminal shown above. Cap unused wires one at a time.
- Restore power and finish setup in the app using the settings below.
- Test heat, cool and fan. If a breaker trips or equipment runs nonstop, power off and call a pro.
App settings to choose
- Set the number of heat and cool stages to match the wires connected.
What you need
- ecobee Smart Thermostat PremiumThe thermostat itselfCheck price
As an Amazon Associate we earn from qualifying purchases, at no cost to you.
Confirm against the official ecobee install guide. The app also checks your wiring during setup.
Frequently asked questions
Where does each wire go on the ecobee Premium?
R → Rc; C → C; W1 → W1; W2 → W2; Y1 → Y1; Y2 → Y2; G → G.
Do I need a C wire for the ecobee Premium?
You already have a C wire, so no adapter is needed.