Wiring guide
ecobee Smart Thermostat Enhanced wiring for heat pump with B valve wire
Good news: the ecobee Smart Thermostat Enhanced is a direct swap for this setup. Every wire has a matching terminal.
Rheem, Ruud and a few other brands energize the reversing valve in heating mode and label it B. Put it on O/B and choose B in settings, or your heat and cool will be backwards. Read the full heat pump with B valve wire guide for how to confirm your setup and mistakes to avoid.
Wiring diagram
Detected system: Heat pump, 1-stage compressor, 1-stage aux heat, fan, C wire present · 6 wires
Your B wire is treated as the reversing valve (energized in heat), common on Rheem and Ruud heat pumps. Set the new thermostat’s O/B setting to B.
ecobee Smart Thermostat Enhanced
Works: direct swap| Wire | Color | Job | Connect to | Note |
|---|---|---|---|---|
| R | red | 24 V power | Rc | |
| C | black | Common (C wire) | C | |
| Y | yellow | Cooling, stage 1 | Y1 | |
| G | green | Fan | G | |
| B | orange | Reversing valve (O/B) | O/B | |
| W2 | white | Auxiliary heat | W1 |
Install steps
- Turn off power to the furnace/air handler (switch or breaker) and the AC condenser. Confirm the old thermostat is dead.
- Photograph the old wiring, then label each wire with the letter it came off. Ignore short jumpers.
- Connect each wire to the ecobee Enhanced terminal shown above. Cap unused wires one at a time.
- Restore power and finish setup in the app using the settings below.
- Test heat, cool and fan. If a breaker trips or equipment runs nonstop, power off and call a pro.
App settings to choose
- Reversing valve (O/B): set to B.
- Equipment type: heat pump with auxiliary (electric strip) heat.
What you need
- ecobee Smart Thermostat EnhancedThe thermostat itselfCheck price
As an Amazon Associate we earn from qualifying purchases, at no cost to you.
Confirm against the official ecobee install guide. The app also checks your wiring during setup.
Frequently asked questions
Where does each wire go on the ecobee Enhanced?
R → Rc; C → C; Y → Y1; G → G; B → O/B; W2 → W1.
Do I need a C wire for the ecobee Enhanced?
You already have a C wire, so no adapter is needed.